For pulling out the housing of 3 and 4 bolt wheel bearings without the need to remove the drive shaft. For use with 18t and 22t cylinders. VW. Audi. Seat. Skoda. Subaru etc.
Bolted bearings often oxidize heavily in the steel or aluminum steering knuckle housing. The old hub is often necessary for a new bearing. Therefore, it must be removed. The jig has been developed for quick work directly under the car. Often, it is not necessary to remove the end of the drive shaft from the hub. To remove the hub, you also need jig 01-00040 or 01-00049. Using the bolts from the old bearing frame and the washers included in the kit. The plate is attached to the bearing frame. To press out the bearing, use jig 01-00026. 01-00047 or 01-00027. You need a hydraulic cylinder 18T or 22T or a slide hammer 1064.