Sanitary epoxy paste. Based on epoxy resin, fiberglass and special moisture crosslinking agents. The product is intended for removing leaks in pressure installations. The epoxy paste does not flow from vertical surfaces and is resistant to chemical agents and weather conditions. It is characterized by very high adhesion to metals, plastics, stone and concrete.

Application examples:
Repair of central heating radiators
Repair of water and sewer pipes

HOW TO USE
1. Find the leak and turn off the water supply. Water must not flow out during the repair, as it may wash away the uncured paste.
2. Before repairing, roughen the surfaces to be repaired with sandpaper or a file.
3. Remove any dirt and grease.
4. Prepare the mixing bowl
5. Place equal amounts of epoxy paste components A+B in the mixing bowl
6. Mix the ingredients thoroughly until a uniform color tone is obtained.
7. Apply a layer of mixed epoxy paste to the surface to be repaired.
8. Place the fiberglass mesh (included) in the paste
9. Leave to stand for approximately 30 minutes for the paste to initially harden.
10. Apply a second coat of mixed epoxy paste to the repair area (following steps 5-7). TIPS AND RECOMMENDATIONS Before mixing the components, place the containers with components A+B in hot water for about 5 minutes. The heated components have a lower viscosity, which makes it easier to remove the required amount from the containers for repair and mix them together.
Do not mix components A+B in larger quantities than you can use within 30 minutes.
The repair time can be shortened by heating the repaired area with hot air.
The areas to be repaired can be reinforced with fiberglass mesh (T-048)

Colour: light blue
Potency after mixing: 30 min.
Initial curing: 120 min. (at +20C)
Full curing: 24 hours
Temperature resistance: -40C to +100C