High-quality adhesive that permanently bonds glass to metal. The product is resistant to UV radiation, moisture, temperature and most chemicals. The brush included in the kit ensures excellent surface coverage and is ideal for large surfaces and hard-to-reach places. To attach the rear-view mirror, use the included shock-absorbing rubber pad.

Usage:
For best results, the surfaces to be bonded must be clean, grease-free and dry.
1. Mark the exact position of the mirror base/holder to be installed on the window glass (it is not recommended to correct it during assembly).
2. Remove the mirror from the holder/mirror base.
3. Apply the adhesive to the metal surface of the mirror holder intended for bonding. The adhesive layer should be thin and as thin as possible.
4. Place the degreased rubber pad on a smooth horizontal surface, e.g. a table, and press it against the mirror holder; hold the pressed elements with equal force for 10 seconds.
5. Cut the excess rubber to the size of the mirror holders support surface.
6. Apply a second, thin and thin layer of adhesive with a brush to the rubber pad attached to the side of the holder.
7. Press the mirror holder firmly, without shifting, and with equal force onto the car window, keeping it under pressure and in place for 20-30 seconds.
8. Leave the holder to stand for at least 1 hour, then attach the mirror to the side of the mirror holder.
Remaining glue holes can be removed using Technicqll Instant Glue Remover (P-093)
Viscosity: 80 cP
Max. gap to be filled: 0.10 mm
Temperature resistance: -55°C to +80°C
Store at: +5°C to +20°C