Suitable for all laminated glass. Makes stone chips and cracks less visible and stops them from cracking further. Not suitable for cracks over 30cm and cracks that run out to the edge of the glass. Reusable - the package is enough to repair several chips. The kit removes air from the glass crack and fills it with repair material. The material hardens under the influence of UV (use a UV lamp or direct sunlight). On multi-layered glass, only one layer is repaired. The best result is achieved if the kit is used immediately after the damage occurs, when water or dirt has not yet had time to penetrate. If the damage is already dirty and wet, there is a chance that the substance will not be absorbed properly for the repair to be satisfactory.

Repairing scratches:

1. Avoid direct sunlight at the beginning of the repair.
2. Clean the damage with dry and clean paper. The glass damage should be dry and clean. If necessary, remove loose pieces of glass with the blade provided.
3. Install the suction cup holder (A) so that its hole is in the center of the damage (picture 2).
4. Screw the guide (B) into the holder so that it gently presses against the center of the damage (picture 3,4)
5. Open the bottle of substance (D) and drip 3-6 drops (depending on the size of the damage) into the guide (B). If the substance starts to flow from the bottom, gently tighten the guide by turning it on.
6. Now screw the pressure nozzle (C) into the guide (B) all the way (picture 6). Let the substance absorb into the damage for about 4-6 minutes.
7. Turn the summer nozzle (C) 1/4 to 1/2 turn so that the substance is completely absorbed.
8. Remove the summer nozzle (C) to let the air escape from the holder (A).
9. Reinstall the summer nozzle (C) to get every last bit of air from the damage to the glass.
10. Now look at the damaged area from the inside of the glass at a 45 degree angle. If there are still air bubbles, repeat steps 6-9 again.
11. If no air is visible, remove everything from the glass.
12. Clean the excess substance from the glass with paper.
13. Where the damaged area is still visible, place a small drop of the agent directly on it. Now place the drying film (E) on the damaged area where the agent was applied. Do not press the drying film.
14. Move the vehicle into direct sunlight or use a UV lamp. The drying time of the agent is 5-10min. depending on the strength of the light. If there is no direct sunlight, the agent will dry longer.
15. Remove the drying film.
16. Check that the agent has dried. Take the blade (F) and scrape off excess material.
17. If the damaged area is still visible, repeat steps 13-15.

1. 1 Avoid direct sunlight at the beginning of the repair.
2. 2 Clean the damage with a dry, clean paper.
3. The damage to the glass should be dry and clean.
4. If necessary, remove loose pieces of glass with the blade provided.
5. Apply the repair material to the glass crack at a speed of 3 seconds per 1cm.
6. Look at the crack from a 45 degree angle to ensure that the crack is filled with the material.
7. Let it absorb for 5-10 minutes.
8. If there is air trapped, press the glass from the inside until the air escapes. Press gently to avoid enlarging the crack.
9. Once the air has been removed, reapply to the entire crack. substance.
10. Install the drying film(s) over the entire repaired area.
11. Move the vehicle into direct sunlight or use a UV lamp. The drying time of the substance is 5-10min. depending on the strength of the light. If there is no direct sunlight, the substance will dry longer.
12. Remove the drying film.
13. Check that the substance has dried. Take a blade(F) and scrape off excess substance.